Overview: Hydraulic control valve
 |
Model XLC410 - Downstream pressure reducing or stabilizing The CSA XLC 410 Series control valve will reduce and stabilize the downstream pressure to a preset value, regardless of variations in demand and upstream pressure fluctuations. |
 |
Model XLC420 - Upstream pressure sustaining or relief The CSA XLC 420 control valve will sustain, if installed in-line, and relief if installed in derivation from the main line, the upstream pressure to a pre-set value regardless of variations in demand. |
 |
Model XLC430 - Flow control The CSA XLC 430 Series flow control valve will automatically limit the flow to a preset value, regardless of pressure variations. In case of flow rate lower than the required set point the valve will be fully opened. |
 |
Model XLC440 - Minimum/Maximum level control The CSA XLC 440 minimum-maximum level control valve will automatically operate an on-off regulation to maintain the tank level within an adjustable range. |
 |
Model XLC450 - Solenoid operated "on/off" control loop The CSA XLC 450 solenoid control valve will either open or close in response to the signals to the solenoid valves. |
 |
Model XLC453 - Solenoid operated "step by step" control loop The CSA XLC 453 step by step solenoid control valve will perform a regulation in response to the signals sent to the solenoid valves.This valve is usually installed in combination with a PLC or managed directly from a remote monitoring system. |
 |
Model XLC460 - Constant level control valve The CSA XLC 460 constant level control valve will automatically maintain the tank level within a range of approximately 15 cm. |
 |
Model XLC470 - Altitude control valve The CSA XLC 470 altitude control valve will maintain the level of a water tower or a tank, with an accuracy of a few cm of water column.The altitude control is regardless of any upstream pressure variations. |
Datasheet XLC410 Series